Home Solicitudes


DIVISIÓN Intelligent Exterior Systems


  • Ensures the tool and injection process tuning from tool study validation until the product quality approved by the customer.
  • Is responsible for the tool and the Injection process reliability at the factory tool transfer.


KPI/Main deliveries:

  • Is main technical contact to toolmaker post M4
  • TCRD FAC list, Trail evaluation, Tool transfer
  • Cycle time, scrap achievements vs. PRU Commetment



  • Takes part to the injection tool concept validation.
  • Takes part to the injection system definition.
  • Brings technical proposals in order to improve the project targets: Quality, Cost, Lead time.
  • Has to be an added value to the innovative proposals.
  • Is the main technical contact with the toolmakers during the project life.
  • Brings added value to the tool purchasing team.
  • Uses on a daily basis the department data base tools ( TCRD , FAC , Action plan, trial evaluation…)
  • Organizes and leads the Trial Preparation Meeting. Is responsible for the Injection Tools trials.
  • Takes part to the trials and manages the needed actions in order to reach the Injection trials targets defined during the Trial Preparation Meeting, in accordance with the safety rules.
  • Takes part to the wash up meeting after the trial and the tuning loop, for the analysis and synthesis of the global results with the core team.
  • Updates the action plan (FAC) and displays the information to the toolmakers.
  • Is responsible for the factory tool transfer stage (Tool, Injection process reliability in relation with the factory specifications).
  • Makes lessons learnt on his project (best practices / bad experiences) and communicate them to Expertise injection & tooling group.
  • Takes part to the customer initial samples parts validation (PPAP / PVS ….).
  • Updates the department data base (Raw material / shrinkage)
  • Follows the Division Quality system and Optimap procedures.
  • Uses the POAE working tools available (quality procedures, Keops, Optimap, Optisup, …)
  • May participate to injection molding meeting (worldwide)


Competences requirements:

  • Knowledge / Qualification


  • Previous Experience (If relevant)
  • Key technical competencies


  • Bachelor’s degree or equivalent


  • 3 or 5 years of significant experience on Injection & tooling field
  • Good level in English
  • Able to understand rheology studies
  • Advanced competencies in Excel, Word, PowerPoint and design software or viewer


<< Volver a la lista